Transmission jacks for controlled drivetrain support and positioning

Industrial Shed’s Transmission Jacks collection contains Kincrome equipment designed for controlled support and positioning of transmissions and related drivetrain assemblies during suitable workshop work. The active range includes a 500 kg single-stage transmission jack, a 1,000 kg dual-stage transmission jack, a 500 kg vertical transmission stand and a 600 kg adjustable transmission support. These products are specialised workshop equipment and must be selected around the vehicle, transmission assembly, lifting points and approved repair procedure.

Choose the support method for the job

A transmission jack supports and positions an assembly from below where the equipment and vehicle layout permit. A vertical stand or adjustable support may suit a different stage of the removal, installation or service process. Compare the supplier-stated capacity, saddle or support arrangement, lifting range, adjustment method and intended application before ordering. Capacity is important, but correct contact with the assembly and controlled access to the work area are equally important.

Stable vehicle support comes first

Transmission equipment does not replace correctly rated vehicle lifting and support equipment. Before working beneath a vehicle, make sure it is raised and supported at the manufacturer-approved points using appropriate equipment. Never work under a vehicle supported only by a jack. For compatible support equipment, browse Jack Stands and Hydraulic Jacks.

Control the assembly throughout the job

Confirm the transmission’s actual weight, centre of gravity and secure mounting before removing fasteners or moving the jack. Keep hands clear of pinch points and do not allow an unsupported component to rotate or shift. Follow vehicle repair information, supplier instructions and workplace safety procedures. If the job requires engine support as well as transmission positioning, see Automotive Lifting & Engine Support.

Transmission jack FAQs

Can I use a transmission jack as a general vehicle jack?

No. Transmission jacks are designed to support and position drivetrain assemblies, not to lift a vehicle. Use vehicle-specific lifting and support equipment for raising and supporting the vehicle.

Why does saddle compatibility matter?

The saddle or support contact must hold the assembly securely and avoid damaging components. Confirm the manufacturer’s guidance and secure the load as required before moving it.

Should I choose a single-stage or dual-stage jack?

Choose based on the required lifting range, capacity, vehicle access and the repair procedure. Review the individual Kincrome specifications rather than selecting by capacity alone.