► Thor Hammer | Faces

Interchangeable Hammer Faces for Controlled Striking & Extended Tool Life

Impact tools don’t fail at the handle—they fail where force meets material. That’s why White International – Thor Hammer faces are engineered as a replaceable system, allowing trades to maintain performance without replacing the entire tool.

Across demanding Australian worksites, Thor hammer faces are relied on where interchangeable striking surfaces, consistent impact control & reduced downtime are critical. Instead of committing to a single material, operators can swap faces based on the job, turning one hammer into a multi-application system.

Built for compatibility across Thor systems, these replacement hammer faces Australia-wide are available in rawhide, plastic & copper. Each material delivers a different response—rawhide protects finished surfaces, plastic handles repeated use, while copper provides higher mass with non-sparking characteristics. This flexibility makes them a core part of any replaceable hammer face system used in industrial environments.

Operating from Somerville, Industrial Shed supplies these interchangeable hammer faces Australia wide to mechanical trades, fabrication workshops & maintenance teams. These systems are widely used across mining, oil & gas & industrial servicing where tools must adapt quickly without interrupting workflow.

Within real jobsite setups, these components integrate directly with Hammers, supporting broader workflows alongside Mallets & general-purpose Hand Tools. Accurate positioning is handled using Measuring & Layout Tools, while components are stabilised through Fabrication Tools & Workholding. Supporting systems include structured storage via Tool Storage & secure assembly using Bolts & Fasteners.

What’s in This Collection:

► Rawhide hammer faces
‣ Non-marking faces designed for surface protection & precision assembly

► Plastic hammer faces
‣ Durable striking faces suited for repetitive, high-frequency use

► Copper hammer faces
‣ High-mass, non-sparking faces for heavy-duty applications

► Screw-in hammer face systems
‣ Threaded designs allowing fast replacement on Thor hammer bodies

► Multiple diameter hammer faces
‣ Range of sizes to suit different hammer weights & applications

► Dual-face hammer configurations
‣ Balanced striking with replaceable faces on both ends

Keeping a mix of face materials available allows trades to respond to different job requirements without switching tools.

Trade Applications for Hammer Faces

Changing materials mid-task is common across real job environments. Interchangeable hammer faces allow operators to adjust striking performance without switching tools, improving efficiency across varied applications.

► Surface-sensitive assembly work
‣ Rawhide faces protect finished components without marking surfaces

► High-cycle workshop operations
‣ Plastic faces handle repeated impact while maintaining consistency

► Non-sparking hazardous environments
‣ Copper faces reduce ignition risk in critical work zones

► Mechanical fitting & staged assembly
‣ Swap faces to match material hardness during installation

► Maintenance & on-site servicing
‣ Replace worn faces immediately to avoid workflow delays

► Multi-material fabrication workflows
‣ Adjust striking response by changing face type instead of tool

Before impact is applied, positioning is confirmed using Measuring & Layout Tools, ensuring consistent results.